The Beadsmith Macrame Crown Knot Bracelet

Back to category
by Beadsmith Design Team

The Beadsmith Macrame Crown Knot Bracelet

A colorful bracelet that goes with so many things!

Project Details

  • Level:intermediate
  • Time:1 hour

Project Instructions

  • 1
    Download and print project template.
  • 2
    Cut two 4 inch pieces of cord. Thread button onto one of the cords. Using step 1 of the Chinese Crown Knot directions on the template, lay your string out with the buttoned cord as the horizontal cord and use the macrame board to hold cords in position.
  • 3
    Continue following the directions on the template until you have made approximately 1-1/2 inch of knots without beads.
  • 4
    Place one bead on the each side of cord, and bring them all the way up to your last knots. Then, make one crown knot.
  • 5
    Repeat previous step, alternating bead colors on the cord ends until you have made approximately 5 inch of beaded crowded crown knots.
  • 6
    Now make approximately 1-1/2 inch of crown knots without beads.
  • 7
    Dab a small amount of super glue onto the last crown knot you made, and take 2 ends and make a simple knot and then the other 2 ends. Add a bit more glue to secure those knots and let dry.
  • 8
    Cut off 2 of the ends. Using the other 2 ends make a loop that will easily slide over the button, wrap the remaining cord around it to make a wrapped loop and add some glue to the wrap to keep it secure. Trim off the ends.

Project Details

  • Level:intermediate
  • Time:1 hour

Project Supplies

  • The Beadsmith Macramé Board 104806483
  • The Beadsmith Chinese Knotting Cord .8 mm Siam 104806439
  • Beader's Paradise Czech Glass Beads 6/0 Cherokee Mix 104251049
  • Super Glue of Your Choice
  • Button to Be Used as a Clasp
  • Scissors
  • Ruler
Download Project Template