Cousin Neon Pop Paracord Cuff Bracelet

Back to category
by Cousin Design Team

Cousin Neon Pop Paracord Cuff Bracelet

Neon + paracord = fun!

Project Details

  • Level:intermediate
  • Time:1 hour

Project Instructions

  • 1
    Cut two 5-1/2 foot lengths of paracord. Use a lighter to singe the ends of the cord to prevent it from fraying and raveling.
  • 2
    Fold each cord so there is a 9 inch length and 57 inch length for each cord. Do not cut.
  • 3
    Line the 9 inch lengths side-by-side and tape them to a flat surface.
  • 4
    Lay the 57 inch lengths on either side, (these will be called the “working cords”).
  • 5
    Make a simple knot by placing the long “working cord” on the right, perpendicular over the two center cords. Place the long “working cord” on the left over the right hand “working cord”. Bring the left hand “working cord” under the two middle cords and over the right hand “working cord”.
  • 6
    Bring this simple knot down the length of the center cords until you reach the length you want your finished bracelet to be.
  • 7
    Secure the ends of the two center cords to a flat surface with tape.
  • 8
    Take the right “working cord” and wrap it around the right cord.
  • 9
    Place the left “working cord” over the left cord, under the two center cords, and over the right cord. Pull the cord tight.
  • 10
    Take the right “working cord” and place it over the middle cords, under the left cord and pull tight.
  • 11
    Begin with steps 8 – 10 again, tightening horizontally and vertically as you weave. Continue weaving up the center cords, (stop weaving when the loops at the top are approximately 1/2 inch long).
  • 12
    Cut the remainder of the working cord lengths to 4 inch.
  • 13
    Singe the ends with a lighter.
  • 14
    Thread the working cords back down and under the middle weave cords to hide and hold the cording in place.
  • 15
    Thread the other loose ends twice through the loop on the clasp.
  • 16
    Thread the ends under the middle weave cords to hide and hold the clasp in place.
  • 17
    Hook the clasp to the loops on the bracelet to complete the closure.

Project Details

  • Level:intermediate
  • Time:1 hour

Project Supplies

  • Cousin Nylon Paracord 18 feet Neon Green 104820613
  • Cousin Nylon Paracord 18 feet Bright Pink 104820615
  • Cousin Swivel Clasp/Bungee Cord End Silver 6 pc. 104820405
  • Scissors
  • Ruler
  • Lighter
  • Pliers
  • Scotch Tape