Cousin Swarovski Chevron Gradient Necklace

Back to category
by Theresa Hyatt, Cousin

Cousin Swarovski Chevron Gradient Necklace

Use your favorite Swarovski crystals to create an elegant chevron necklace with a stylish gradient twist.

Long-time jewelry wearer, first-time jewelry maker? Our Jewelry Making videos can help you complete this project.

Make it, snap a pic and share using #ACMooreInspired.

Project Details

  • Level:beginner
  • Time:30 minutes + dry time

Project Instructions

  • 1
    Glue five Meridian Blue flat back crystals onto a slide chevron. Repeat this step with Tanzanite, Aquamarine, and AB Crystal flat backs for a total of four chevron accents. Allow glue to dry.
  • 2
    Remove the six Silver rounds from the ear wires in the Swarovski Silver starter pack.
  • 3
    Slide a head pin up through the holes on each side of the four chevrons, with a Silver round from step 2 in between each chevron, in the following order: Meridian Blue, Tanzanite, Aquamarine, and AB Crystal. Form a loop at the top of the head pins.
  • 4
    Remove the jump ring and lobster claw clasp from one Silver chain and the jump ring from the other chain.
  • 5
    Connect the remaining jump ring from the end of one chain to the remaining lobster claw clasp from the end of the other chain.
  • 6
    Connect the tiny loop ends of the two chains to each head pin loop at the top of both sides of the connected chevrons from step 3.

Project Details

  • Level:beginner
  • Time:30 minutes + dry time

Project Supplies

  • •A Package of Cousin Swarovski 3 mm Xirius Flat Backs in AB Crystal, Aquamarine, Tanzanite & Meridian Blue, Four Packages of 3-Hole Slide Chevrons, One Silver Starter Kit & Two Silver Chains
  • •Cousin 3 pc. Tool Set (you will need the Needle Nose Pliers & Round Nose Pliers)
  • •Panacea 8" Heavy Duty Wire Cutters
  • •Tweezers & Glue or Other Adhesive