Fabric Editions Fabric Palette Monogram Hoop
Back to categoryFabric Editions Fabric Palette Monogram Hoop
Make it personal with your own monogram!
Project Details
- Level:beginner
- Time:1/2 hour
Project Instructions
-
1Project time does not include drying time for the glue.
-
2Loosen the screw and separate the two parts of the hoop. Set the inner hoop aside.
-
3Lay the burlap on a surface so its flat and smooth. Place outer hoop on the burlap with the screw at the top of the hoop. Check that the burlap extends at least 1 inch all around the hoop when centering the design.
-
4Carefully slip the inner hoop under the burlap and align it with the outer hoop. Note: Keep the screw at the 12 oclock position and the design centered and straight in the upper hoop. Press outer hoop over inner hoop. Grasp burlap edges on opposite sides of the hoop and pull so that the design is taut in the hoop. Tighten screw.
-
5Trim burlap 3/4 inch from the outside of the hoop. Glue edges neatly to the inside of the hoop.
-
6Center the letter on the burlap in the hoop. Mark position with tape. Remove and apply glue to the back; attach securely to the burlap. Remove tape.
-
7Tie a bow with the ribbon around the hardware at the top of the hoop. Trim ends to be even.