Nicole's™ Bead Shop Down to Wire Bead & Jump Ring Bracelet

Back to category
by Nicole's™ Bead Shop Design Team

Nicole's™ Bead Shop Down to Wire Bead & Jump Ring Bracelet

Make this in less than 15 minutes!

Project Details

  • Level:intermediate
  • Time:5 minutes

Project Instructions

  • 1
    Note: two pair of needle nose pliers are needed to complete this project.
  • 2
    Make two jump ring chains: one 7 jump rings long and one 3 jump rings long.
  • 3
    Cut a 12 inch length of beading wire. String the following onto the beading wire: an acrylic bead, a wood sparkle bead, an acrylic bead, a wood sparkle bead and an acrylic bead. Slide half the open 4 mm jump rings onto the beading wire on each side of the beads. Slide a crimp tube onto each end of the wire.
  • 4
    Slide a crimp tube onto one end of beading wire. Thread the wire through a jump ring on one end of the 7 jump ring chain from step 2, back through the crimp tube to the desired length for the wrist, and close the crimp tube. Trim off excess beading wire.
  • 5
    Slide a crimp tube onto the other end of the beading wire. Thread the wire through the jump ring on one end of the 3 jump ring chain from step 2, back through the crimp tube to the desired length for the wrist, and close the crimp tube. Trim off excess beading wire.
  • 6
    Attach a lobster claw clasp to the jump ring on the other end of the 3 piece jump ring chain.

Project Details

  • Level:intermediate
  • Time:5 minutes

Project Supplies

  • Nicole's™ Bead Shop Shambala Brown/White Polka Dots 15 pc. 104801509
  • Cousin Jewelry Basics Jump Rings 4 mm and 6 mm Antique Gold 400 pc. 104563114
  • Cousin Jewelry Basics 7 mm x 9 mm Lobster Claw Clasp Antique Gold 24 pc. 104563276
  • Cousin Jewelry Basics Crimp Tubes 2 mm Antique Gold 500 pc. 104563454
  • Cousin Tool Basics Value Pack 3 pc. 104257385 (2)
  • Crimping Pliers
  • 7-Strand Gold Beading Wire