Light Up the Night Stenciled Votive

Back to category
by Brittany Hurley, A.C. Moore

Light Up the Night Stenciled Votive

Brighten up your home with this votive holder. Use Nicole™ Crafts vinyl as stencils and Rust-Oleum® Fluorescent Spray Paint to add patterns to any glassware for the perfect table décor for your summer party!

Project Details

  • Level:
  • Time:

Project Instructions

  • 1
    Prepare area with newspaper or plastic sheeting to protect the area from spray paint. Read all directions for Rust-Oleum spray. It is best to work outside or in a well-ventilated area. Make sure the glass surface is clean.
  • 2
    Trace the side of the cube on the vinyl sheet and cut out square. Note: In this project only two sides of the cube are patterned. Your square should contain three rows of three clovers.
  • 3
    Remove the back paper sheet of the vinyl sheet and carefully position the decal on the surface. Rub stencil backing with a craft stick to make sure it is firmly adhered. Peel off backing sheet, leaving black vinyl stencil on glass. Repeat for each side.
  • 4
    Spray an even coating of neon paint to each side of the cube. Let dry. Repeat with another 1-2 coats until desired color is achieved. Let dry completely.
  • 5
    To finish, use a craft knife to remove the decals from the glass.

Project Details

  • Level:
  • Time:

Project Supplies

  • Chelsea Home Imports Square Glass Cube 5 inch 104185793 
  • Rust-Oleum® Fluorescent Spray Paint 11 oz. Yellow 104131460 
  • Nicole™ Crafts Vinyl Transfer Pattern Sheet 8-1/2 inch x 13-1/2 inch Moroccan 104752445
  • Craft Stick
  • Craft Knife