Morex Neon Jeweled Flat Braided Bracelets

Back to category
by Morex Design Team

Morex Neon Jeweled Flat Braided Bracelets

The neon and bright Morex Neon Jeweled Flat Braided Bracelets is fun and easy to make!

Project Details

  • Level:intermediate
  • Time:1 hour

Project Instructions

  • 1
    Cut four ribbons about one-third longer than the desired finished length of the bracelet.
  • 2
    Make a Rolled Four Ply Braid: Pin ribbons in sets of two at right angles to each other; weave them together as shown in the picture. Roll the two left ribbons to the right at right angles. Roll the far right ribbon under the adjacent ribbon, over the next and under the last. Repeat with the ribbon that is now on the far right. Roll the two left ribbons to the right at right angles. Roll the far right ribbon under the adjacent ribbon, over the next and under the last. Repeat with the ribbon that is now on the far right. Continue in this pattern until you have the desired length.
  • 3
    Sew joining ends together. Cut off any excess. Seal any ends with fray check.
  • 4
    Glue on your favorite jewels.

Project Details

  • Level:intermediate
  • Time:1 hour

Project Supplies

  • Morex Grosgrain Ribbon 3/8 inch x 15 yard Turquoise 104443909
  • Morex Grosgrain Ribbon 5/8 x 10 yard Key Lime 104753345
  • Morex Grosgrain Ribbon 3/8 inch x 15 yard Neon Tangerine 104753355
  • Morex Grosgrain Ribbon 3/8 inch x 15 yard Neon Fuschia 104753353
  • Aleene's Fabric Fusion Permanent Fabric Adhesive 4 oz. 104148214
  • Straight Pins
  • Sharp Scissors
  • Fray Check