Morex Ribbon Fish

Back to category
by Morex Design Team

Morex Ribbon Fish

Nemo would be jealous with the look of this cute little fish! Great for a children’s party craft.

Project Details

  • Level:beginner
  • Time:10 minutes

Project Instructions

  • 1
    Cut a 10" long piece of 7/8" Dazzle ribbon.
  • 2
    Next, fold over as shown and glue the overlapping pieces. This will be the body of the fish.
  • 3
    Cut a piece of 3/8" Dazzle 2" long.
  • 4
    Wrap this piece around the body of the fish. Be sure to glue it down so the seam is on the back.
  • 5
    The remaining pieces sticking out will be the tail. Make a fishtail cut on each of these to complete the look.
  • 6
    Cut two 1-3/4" long pieces of 3/8" Dazzle. Fold these over and glue the ends together to make fins.
  • 7
    Next, adhere the bottom of the fins to the back of the body.
  • 8
    For the final touch, glue one wiggle eye in place on the body. ou’re done!
  • 9
    Try experimenting with different colors and sizes for a rainbow of fish!
  • 10
    Tip: Dazzle does not have to be sealed. It will not fray. However, if you are using another Grosgrain it would be good to seal the ends.

Project Details

  • Level:beginner
  • Time:10 minutes

Project Supplies

  • Morex Dazzle Glitter Grosgrain Ribbon 7/8 inch Turquoise 104600999
  • Morex Dazzle Glitter Grosgrain Ribbon3/8 inch Turquoise 104600957
  • Nicole™ Crafts Wiggle Round Eyes 5 mm 144 pc. 104234510
  • Nicole™ Crafts Dual Temperature Trigger Glue Gun 104180411
  • Surebonder® All Purpose Stik™ Glue Sticks 4 inch 50 pc. 104737928
  • Scissors
  • Ruler