FloraCraft® Triple Wreath Door Hanger

Back to category
by Dondi Richardson, FloraCraft®

FloraCraft® Triple Wreath Door Hanger

Welcome fall to your house with this door hanger. Choose the ribbons you like best so you create a door hanger that is uniquely your own.

Project Details

  • Level:advanced
  • Time:2 hours

Project Instructions

  • 1
    Lay the wreaths side by side on a table. Insert craft sticks or wood picks where the wreaths meet and glue together to secure with low temp glue.
  • 2
    Pin one end of the garland to the top of the top wreath. Bend it down the left side, pinning in place.
  • 3
    Bend the garland across the top of the middle wreath and down the right, pinning as you go. Then bend it back across the top of the bottom wreath and down the left side pinning to secure at the bottom.
  • 4
    Cut apart the stems of berries and glue into the garland evenly spaced.
  • 5
    Pin one end of the ribbon at the top of the wreath and wind it in and out of the garland, pinning as you go.

Project Details

  • Level:advanced
  • Time:2 hours

Project Supplies

  • FloraCraft® Straw Wreath 12 inch 104183783 (3)
  • Nicole™ Crafts Garland Autumn 29 inch Berry 104755440 (2)
  • Nicole™ Crafts Leaves Stem 22 inch Maple Berry 104604127
  •  Coordinating Wired Ribbon
  • Nicole™ Crafts Floral Greening Pins 50 pc. 104186729
  • Loew-Cornell Craft Sticks 250 pc. 104141494
  • Nicole™ Crafts Dual Temperature Trigger Glue Gun 104180411
  • Scissors
  • Panacea™ Heavy Duty Wire Cutters 104455865