Light Up the Night Stenciled VotiveBack to category
Light Up the Night Stenciled Votive
Brighten up your home with this votive holder. Use Nicole Crafts vinyl as stencils and Rust-Oleum® Fluorescent Spray Paint to add patterns to any glassware for the perfect table décor for your summer party!
1Prepare area with newspaper or plastic sheeting to protect the area from spray paint. Read all directions for Rust-Oleum spray. It is best to work outside or in a well-ventilated area. Make sure the glass surface is clean.
2Trace the side of the cube on the vinyl sheet and cut out square. Note: In this project only two sides of the cube are patterned. Your square should contain three rows of three clovers.
3Remove the back paper sheet of the vinyl sheet and carefully position the decal on the surface. Rub stencil backing with a craft stick to make sure it is firmly adhered. Peel off backing sheet, leaving black vinyl stencil on glass. Repeat for each side.
4Spray an even coating of neon paint to each side of the cube. Let dry. Repeat with another 1-2 coats until desired color is achieved. Let dry completely.
5To finish, use a craft knife to remove the decals from the glass.