Anikka Bracelet

Back to category
by Brittany Hurley, A.C. Moore

Anikka Bracelet

This bracelet combines the sleekness of metal with a pop of color for an accessory that makes a statement.

Project Details

  • Level:beginner
  • Time:1 hour

Project Instructions

  • 1
    Measure and cut a length of chain to fit your wrist size. At one end, attach the lobster clasp with a jump ring and on the other attach just a jump ring for the closure.
  • 2
    Measure a piece of paracord the length of your bracelet plus an additional 5 inches.
  • 3
    At one end of the bracelet, tie the paracord to the last link of the chain.
  • 4
    Cut a piece of DMC floss a length double the size of the bracelet. Tie it the chain at the same link where the paracord was fastened on. Then use DMC floss to attach the paracord by weaving the floss through the chain.
  • 5
    Tie the other end of the paracord to the last link of the chain. Then tie the DMC floss to the same link.
  • 6
    Finish by cutting off excess tails of paracord and floss and using a light to singe the ends of the paracord to prevent running.

Project Details

  • Level:beginner
  • Time:1 hour

Project Supplies

  • Cousin® Jewlery Basic Large Flat Chain Silver 16 inch 104525140
  • Pepperell 325 Paracord Neon Pink 104750194
  • Nicole™ Crafts Lobster Clasp 12mm Silver 2 pcs. 104244079
  • Nicole™ Crafts Jump Ring Silver 350 pcs. 104240705
  • DMC® Floss
  • Beadalon® Round Nose Pliers Designer Ergo 104458308
  • Lighter
  • Scissors
  • Wire Cutters