Nicole™ Crafts Chain Rhinestone Bracelet

Back to category

Nicole™ Crafts Chain Rhinestone Bracelet

Make a trendy rhinestone bracelet in no time at all with curb chain and rhinestones from Cousin! Mix and match metal finishes, add in threads, yarn...have fun becoming your own jewelry designer!

Project Details

  • Level:beginner
  • Time:1/2 hour

Project Instructions

  • 1
    Cut a 6 inch piece of rhinestone chain. Place one crimp-on-end on one end crystal and use the flat-nose pliers to push the prongs down to secure. Repeat on the other end crystal.
  • 2
    Cut two 7 inch pieces of chain. Hold both chains together, side-by-side, at one end. Hold crystal chain on top of chains. Wire both chains together, with crystal chain on top. Trim ends of wire.
  • 3
    Cut a 20 inch piece of black cording. Tie one end of each chain together, keeping end at back of bracelet. Tuck end behind wire. Wrap cording through chains and around crystals as shown. When you get to the end, tie both chains together, keeping end at back of bracelet. Tuck end behind wires.
  • 4
    Place a 9mm jump ring on the end of each chain at one end of bracelet. Place another 9mm jump ring through both previous rings. Repeat for the other side. These 9mm jump rings replace the jump rings on the lobster clasp. Attach one end of lobster clasp to one jump ring.
  • 5
    Cut a 6 inch piece of rhinestone chain. Place one crimp-on-end on one end crystal and use the flat-nose pliers to push the prongs down to secure. Repeat on the other end crystal.
  • 6
    Cut two 7 inch pieces of chain. Hold both chains together, side-by-side, at one end. Hold crystal chain on top of chains. Wire both chains together, with crystal chain on top. Trim ends of wire.
  • 7
    Cut a 20 inch piece of black cording. Tie one end of each chain together, keeping end at back of bracelet. Tuck end behind wire. Wrap cording through chains and around crystals as shown. When you get to the end, tie both chains together, keeping end at back of bracelet. Tuck end behind wires.
  • 8
    Place a 9mm jump ring on the end of each chain at one end of bracelet. Place another 9mm jump ring through both previous rings. Repeat for the other side. These 9mm jump rings replace the jump rings on the lobster clasp. Attach one end of lobster clasp to one jump ring.

Project Details

  • Level:beginner
  • Time:1/2 hour

Project Supplies

  • Cousin® Jewelry Basics Large Double Link Chain 30 inch 104525039
  • Cousin® Jewelry Basics Chain Rhinestone 18 inch Crystal/Silver 104525162
  • Cousin® Jewelry Basics Jump Rings 9MM Silver 200 pcs. 104563256
  • Nicole™ Crafts Lobster Clasp 12mm Silver 8pcs. 104240710
  • Beadalon® RoundWire 24 Gauge 28 gauge Silver 104737371
  • Nicole™ Crafts BeadIt™ Imitation Leather Cording 1MM Black 104247916
  • Nicole™ Crafts Flat Nose Pliers 104248455