Nicole™ Crafts Wrapped Bracelet

Back to category

Nicole™ Crafts Wrapped Bracelet

Make a stackable bracelet in your favorite color! These bracelets are all the rage and can be customized with any color DMC embroidery floss, leather and rhinestone chain.

Project Details

  • Level:beginner
  • Time:1/2 hour

Project Instructions

  • 1
    The finished length of the bracelet is 7 inches. It is designed to fit on the wrist snugly. To adjust the fit, make the final knot further along the length of the leather cording. You can also make this bracelet four or five times as long to wrap several times around your wrist.
  • 2
    Fold the length of the cording in half to form a loop. Check the loop for fit around your bead. Wrap the floss around the leather cording at the base of the loop tightly. Tuck the short end of the floss under your wrapping to secure.
  • 3
    Cut a 6 inch piece of rhinestone chain. Place one crimp-on-end on one end crystal and use the flat-nose pliers to push the prongs down to secure. Thread end of floss through hole and place crystal strand against leather cording. Wrap floss around crystal strand twice between each crystal until the end.
  • 4
    Place one crimp-on-end on the last crystal and use the flat-nose pliers to push the prongs down to secure. Thread end of floss through hole and wrap around two times and thread floss under last wrap.
  • 5
    Thread floss through bead. Bring both strands of cording and floss together and tie a knot. Check bracelet fit and adjust accordingly. Pull knot tightly and trim excess leather and floss.
  • 6
    The finished length of the bracelet is 7 inches. It is designed to fit on the wrist snugly. To adjust the fit, make the final knot further along the length of the leather cording. You can also make this bracelet four or five times as long to wrap several times around your wrist.
  • 7
    Fold the length of the cording in half to form a loop. Check the loop for fit around your bead. Wrap the floss around the leather cording at the base of the loop tightly. Tuck the short end of the floss under your wrapping to secure.
  • 8
    Cut a 6 inch piece of rhinestone chain. Place one crimp-on-end on one end crystal and use the flat-nose pliers to push the prongs down to secure. Thread end of floss through hole and place crystal strand against leather cording. Wrap floss around crystal strand twice between each crystal until the end.
  • 9
    Place one crimp-on-end on the last crystal and use the flat-nose pliers to push the prongs down to secure. Thread end of floss through hole and wrap around two times and thread floss under last wrap.
  • 10
    Thread floss through bead. Bring both strands of cording and floss together and tie a knot. Check bracelet fit and adjust accordingly. Pull knot tightly and trim excess leather and floss.

Project Details

  • Level:beginner
  • Time:1/2 hour

Project Supplies

  • Cousin® Jewelry Basics Chain Rhinestone 18 inch Crystal/Silver 104525162
  • Nicole™ Crafts BeadIt™ Imitation Leather Cording 1MM Black 104247916
  • Nicole™ Crafts Flat Nose Pliers 104248455
  • DMC® embroidery floss color of your choice
  • Large bead (approx. 12MM) for closure