Fiskars Easter Egg Holders

Back to category
by Lisa Storms, Fiskars

Fiskars Easter Egg Holders

Give your little bunnies personalized Easter egg holders so they can show off their egg-cellent artwork!

Create your own, snap a picture, and share using #ACMooreInspired.

Project Details

  • Level:beginner
  • Time:about a half hour

Project Instructions

  • 1
    Nest Holder:
    Step A: Using circle cutter, cut a 6" circle from Light Kraft cardstock. Beginning at the outer edge, cut a rugged spiral to the center (see image below). Make choppy cuts to give randomness to the edges.
    Step B: Crumple up cardstock spiral to distress. Adhere the tip of the spiral to a thin cut from an empty paper towel roll as shown. Loosely wrap the rest of the spiral around the holder and adhere (low temp hot glue works great) to a piece of brown cardstock. Once dry, trim off excess cardstock from scrap.
    Step C: Cut a few thin slivers of leftover cardstock and spiral around an opened paper clip. Adhere randomly around nest for extra texture to complete.
  • 2
    Flower Holder:
    Step A: Cut a one inch wide strip of Green cardstock long enough to fit around egg with a little excess; roll and tape closed.
    Step B: Cut ovals from template onto Pink and Lavender cardstock. Fold over tip of each oval and adhere around interior of roll. Repeat with a row of smaller ovals if desired (see image below).
    Step C: Gently round each oval for dimension.
  • 3
    Grass Holder:
    Step A: Cut an approximately 1-3/4" wide strip of Green cardstock long enough to fit around egg with slight overlap. (Width can be adjusted to fit particular letter stickers if needed.) Then, cut an approximately 1-3/8" wide strip of lighter Green cardstock one quarter inch longer than the original strip.
    Step B: Use the craft knife to cut a tight zigzag pattern that resembles grass details.
    Step C: Add letter stickers for a name and gently curl out blades of grass for dimension.

Project Details

  • Level:beginner
  • Time:about a half hour

Project Supplies

  • •Fiskars 3 pc. Circles/Ovals/Rectangle Templates, Circle Cutter and Detail Knife
  • •Nicole™ Crafts Cardstock in Light Kraft, Pink, Lavender & Two Different Shades of Green and Dual Temperature Glue Gun (set to low)
  • •Pop Up Glue Dots
  • •Dyed (and Dry) Easter Eggs, One Inch as well as Half Inch Letter Stickers, Paper Clips and Ruler