We R Fuse Thank You CardBack to category
We R Fuse Thank You Card
We've got the ingredients for a DIY card that'll wow you and the recipient! Take a sprinkle of Fuseable paper and tools, then add a dash of embellishments -- such as sequins, rhinestones or beads -- and Fuse. In just minutes, you'll have a card that's sure to impress!
Make one, then snap a pic and share it: #ACMooreInspired.
- Time:about 30 minutes
1Cut a piece of paper from the Fusable paper pack down to 12" x 5-3/4". Score at 4" and 8". Hand cut, punch or die cut a square opening of 2-3/4" x 2-3/4" in the middle section. Hand cut, paper punch or die cut a Polaroid shape (set die cut aside for now).
2 Cut two 3" x 3" squares out of the 12" x 12" Clear sheets. Plug in tool and allow to heat. Once it's ready, take your two pieces and fuse the bottom and two sides. Create a pocket by filling with beads, rhinestones and/or sequins then fuse the top closed.
3Fuse your pocket to the back of the opening of the card on all four sides. Fuse the Polaroid die cut from step 1 to the front of the card.
4Cut a strip of White paper (off of the stripe-patterned in the Fusable paper pack), write "Thank You" and fuse on top of the Polaroid die cut.
5Use the Fuse tool and one of the decorative tips to create a decorative edge on the top and bottom right sides of the card. Then cut a small banner piece from the Fusable paper pad and Fuse it to the top right side of the card, under the decorative edge.
6Fold the right piece backwards (this will hide your pocket and create a nice look for inside for your card). Fuse this piece so your flap will stay closed. Fold the left piece backwards. Take baker's twine and wrap it double and tie a knot at the top.