Pin end of 1-1/2 inch Red satin ribbon to wreath. Wrap entire wreath with ribbon and secure with pin. Trim ribbon.

Using Kelly Green mesh while on roll, gather end and pin to the ribbon-covered wreath. Slide your hand down the roll of mesh 12 inch and pull mesh forward into a loop. Pin loop to wreath. Continue process around entire wreath. Trim excess Kelly Green mesh.

Repeat step 2 with Red mesh around edge of wreath. Remember to trim your excess mesh.

Cut 9 yard of Red tubing. Fold tubing in half and then in half again. Tie center into a bow. Cut loops and glue to bottom of wreath.

Glue one end of remaining tubing in between Kelly Green and Red mesh at bottom of wreath on one side of bow. Slide one Gold ornament onto tubing and glue ornament to top of Kelly Green mesh. Continue around wreath with tubing and ornaments, leaving at least 6 inch between each ornament as shown. Cut end of tubing and glue in between Kelly Green and Red mesh on other side of bow.

Glue one Gold ornament to center of bow.