FloraCraft® Witch Hat Placecard HolderBack to category
FloraCraft® Witch Hat Placecard Holder
Make a FloraCraft® Witch Hat Placecard Holder for each of the guests at your Halloween party so they know where to sit for the ghoulishly good time you have planned!
- Time:1 hour
1Makes 1 placecard holder.
2Place the cone into the bag. If you have trouble fitting the cone into the opening of the bag, roll the bottom edge of the cone on the table to slightly round the edge. You want the bottom of cone to fit snug into the bottom of the bag. The corners of the bag will stick out on each side; secure the corners to the bottom of the cone with glue. The cone will be slightly taller than the bag. Break the tip of the cone off where the bag ties closed and pinch and shape the top of the cone back into a point with your fingers.
3Tie the bag closed tightly over the top of the cone.
4Pin a length of Black boa around the bottom of each cone for the brim of the hat.
5Cut a 5 inch piece of wire and bend a tight coil into the wire to hold the place card. Glue gems to the end of the wire then glue the end into the top of the cone, through the bag.
6Cut 2 inch circles from the Midnight cardstock. Write the guests name in White chalk on the circle and then insert it into the coiled wire.